The ESP10KL sits at the top of the ESP range, delivering 10,500 lumens (10,700 measured at centre) from the same single-chip DLP engine and 0.67-inch DMD used across the three models below it, at a native 1920*1200 resolution in 16:10. The chassis measures 486 * 393 * 174 mm and weighs 12 kg, so a mount already specified for the 8,600-lumen body carries this unit without modification.
What is new at this output level is the second power figure: 505 W in standard mode and 260 W in eco — roughly half the draw. Fan noise is 36 dB in standard mode and 27 dB in eco, a 9 dB drop. Edge fusion and geometry correction are built in, and 4K 3840*2160 is accepted over HDMI 2.0 and scaled to the panel.
At this output a two-unit wall is usually the whole point. Fusion and geometry correction are inside the chassis, so the second projector and an HDMI split are the whole rig — no blend server, no PC on site. 3D-Sync runs BNC in and out to chain the pair, HDBaseT carries the picture back to the rack over a single Cat run, and the 12V flip-flop fires a screen or a lift off the same command. Plan the ±15% horizontal shift into the mounts before the units go up: on a side-by-side wall the positions do the work, not the shift.
The ESP Series is specified for four venue types: Exhibition, Education, Corporate and Immersive Experience. This is the Exhibition and Immersive Experience body of the four — a hall wall too big for one lower-output unit, a booth that has to read under rig lighting, or an immersive room where the image lands on more than one surface.
Throw ratio is 1.2–1.5:1, so the mounting distance follows the screen width. Send the wall size and the distance you have and the position can be confirmed before the order ships. Wider and longer throws for this body are on the ESP compatible lens sheet and are ordered separately.
| Power Supply | 100–240 V AC, ±10%, 50 or 60 Hz |
|---|---|
| Power Consumption | 505 W standard, 260 W eco, 0.5 W or less on standby |
| Operating Conditions | 5 to 40 °C non-condensing, 10 to 85% humidity, up to 2,500 m altitude (High Altitude Mode at 1,500 m or above) |
| Laser Life | 20,000 hours standard, 25,000 hours in eco |
| Ingress Protection | IP5X |
A power cord, a VGA cord and a remote control.
Ordering note: Send the wall size, the mounting distance and the control system, and we will confirm the throw position, the lens and the port configuration before you order.
